?????????????
????Nand flash ?????????????????洢?豸????????Nand flash?????????Linux???Nand Flash??????
??????????????????γ?????????????????“$”???????????????У?“#”???????????С?
????????黷????
?????? ??????Ubuntu 10.10 (64bit)??
?????? ??????FS_S5PC100????
?????? ?????????????arm-eabi-4.4.0??Android4.0.4??????湤????????
????????鰈?衿
????1. ??????????
??????????????????Nand flash??????
?????? ????s3c_nand.c??drivers/mtd/nand?￡?
?????? ????regs-nand.h??arch/arm/mach-s5pc100/include/mach?￡?
????cp s3c_nand.c drivers/mtd/nand
????cpregs-nand.h arch/arm/mach-s5pc100/include/mach
????2. ??????
????????????nand flash?豸?????drivers/mtd/nand/nand_base.c??2975?С?
????for (i = 0; i< 5; i++)
????3. ??????????
?????? ???drivers/mtd/nand/Kconfig????if mtd_nand??216?У?????????????????
config MTD_NAND_S3C
tristate "NAND Flash support for S3C SoC"
depends on (ARCH_S3C64XX || ARCH_S5P64XX || ARCH_S5PC1XX
|| ARCH_S5PC100) && MTD_NAND
help
This enables the NAND flash controller on the S3C.
No board specfic support is done by this driver?? each board
must advertise a platform_device for the driver to attach.
config MTD_NAND_S3C_DEBUG
bool "S3C NAND driver debug"
depends on MTD_NAND_S3C
help
Enable debugging of the S3C NAND driver
config MTD_NAND_S3C_HWECC
bool "S3C NAND Hardware ECC"
depends on MTD_NAND_S3C
help
Enable the use of the S3C's internal ECC generator when
using NAND. Early versions of the chip have had problems with
incorrect ECC generation?? and if using these?? the default of
software ECC is preferable.
If you lay down a device with the hardware ECC?? then you will
currently not be able to switch to software?? as there is no
implementation for ECC method used by the S3C